TTL Setup: Audio-Technica AT-LP60X / Kanto YU
Congratulations on your new TTL Setup! Here are detailed instructions on how to completely set up your Audio-Technica AT-LP60X turntable and Kanto YU speakers, plus some tweaks for optimizing the setup.
1.0 SET UP YOUR KANTO SPEAKERS
1.1
Unpack your speakers and place them where you want them in your room. Note that the speakers can be no more than 8 Feet apart.
1.2
Make sure the power switch is in the off position and plug the speaker into an outlet. (Note: only one speaker will be plugged into power outlet).
Locate the clear speaker wire and use it to connect the (2) speakers. This cable carries the audio signal and power to the "satellite" speaker.
2.0 SET UP YOUR AT-LP60XUSB TURNTABLE
Please refer to this quick video to get your AT-LP60X turntable set up.
3.0 CONNECT YOUR TURNTABLE TO SPEAKER AS SHOWN
4.0 POWER UP + PLAY
- Turn on the power switch on the back of the speaker.
- Put on a record.
- Hit the start button on the turntable.
- If you don't hear your record, press the speaker's volume button to select the correct input. You can also use your remote to select the right input.
- Hear a buzz or low volume? Make sure the switch on the back of the turntable is set to "LINE".
5.0 UPGRADES
There aren't many mods you can make to the LP60X, however you can swap out the stylus cheaply with the ATN91R Stylus ($39). This upgrade improves tracking and sound quality with the ATN91R's metal cantilever (vs. the stock carbon fiber).
