Congratulations on your new TTL Setup! Here are detailed instructions on how to completely set up your Audio-Technica AT-LP70X turntable and Edifier MR4 speakers, plus some tweaks for optimizing the setup.
1.0 SET UP YOUR SPEAKERS
1.1
Unpack your Edifier speakers and place them where you want them in your room. The Speaker with knobs on the side should be on your left side. Note that the speakers can be no more than 8 Feet apart.
1.2
Turn the speakers around so the back panels are facing you. Make sure the power switch is in the off position and plug the speaker into an outlet. (Note: only one speaker will be plugged into power outlet).
Locate the clear speaker wire and connect the speakers together. This cable carries the audio signal and power to the "satellite" speaker.
2.0 SET UP YOUR AT-LP70X TURNTABLE
Please refer to this quick video to get your AT-LP70X turntable set up.
3.0 CONNECT YOUR TURNTABLE TO THE SPEAKER
Now connect your turntable to the speaker using the RCA cable that comes with your turntable.
Double check the 'PHONO || LINE' switch is set to LINE.
NOTE: You will not need the groundwire (wire with U-shaped connections that comes with your turntable) because we are using the turntable's built-in preamp. If you want to use an external preamp, you'll need to connect the groundwire.
3.1 POWER UP + PLAY
Turn on the power switch on the front of the speaker. 2) Put on a record. 3) Press the start button on the front of the turntable.
Your record should now be playing. If you have any further issues, please contact customerservice@turntablelab.com.
4.0 UPGRADES
For a quick and easy to install upgrade, we recommend AT-VMN95EN stylus. This stylus features a nude elliptical stylus which is a big sound upgrade over the stock model (bonded diamond tip stylus). It's easy to install, just slide off the blue stylus and slide on the new stylus.
